If you install a router that handles the Internet connections of your local network, it uses the public IP address which your Internet service provider assigned to you to communicate with other machines on the Internet. For reasons of simplicity and scarcity of IPv4 addresses, your ISP only assigns one address to your router, independent of how many machines are operating in your LAN. Each of your machines has a "local" IP address. Now the router has to employ a method to multiplex one "public" IP address to multiple "private" IP addresses in your LAN. This is done by NAT port forwarding.
All connections on the Internet can be identified by four parameters:
When one of the computers in your LAN initiates a connection to a server on the public Internet, it selects a source port number and establishes a connection to a certain destination IP address and port number. The source IP address for packets on this connection is the local ("private") address. However, this IP address is only valid in the LAN behind the router, but not on the Internet (hence the attribute "private").
So packets from the Internet can get back to your computer, the router maps your computer's local IP address and port number to a public IP address and port number. Typically, the port number is kept, but the local IP address must be replaced by the public IP address. The router modifies all packets sent to the remote server as long as the connection is alive. When the router receives a packet from the remote server for a mapped port, it uses the same port mapping to send the packet to the right computer on your LAN. For outgoing connections the router can establish this port mapping automatically.
Connections from 192.168.2.11:4242 to 184.108.40.206:80 are mapped to connections from 220.127.116.11:4242 to 18.104.22.168:80.
However, this automatic mapping is not possible for incoming connections. When someone from the Internet wants to establish a connection to one of the computers in your LAN, all your router sees is your public IP address as destination IP address and some port number, but it has no way to know to which local computer the packet should be forwarded. Therefore, you need to configure this mapping manually.
Usually the destination port number of incoming connection requests determines the local destination. You can set up your router accordingly, so that a certain destination port is always forwarded to a specific computer. If a new packet arrives from the Internet, your router replaces the public IP address and port number with their local counterparts that you had configured and then forwards the packet to the right local computer.
So from the standpoint of the public Internet all your local computers are just one machine with one public IP address and several established connections.
Get a free cFosSpeed and cFos Personal Net license! (If your router isn't already listed here)
Help us to complete our router guide.
Write instructions of how to set up NAT port forwarding with your router.
Viper DSL-2900AL Dual Band AC1900
AC750 Archer C20i
If you would like to earn a license key for cFosSpeed and cFos Personal Net by sending us instructions for this router, you can contact us by clicking on the button below.
(If your router isn't already listed here)
The instructions should contain some screenshots and a step-by-step guide, which can be followed easily (see example).
The numbers to mark the specific steps in your screenshots can be downloaded here. Please don't use other means (e.g. arrows or circles) to mark the steps
The screenshots should not be scaled down and saved as 24-bit PNG or high quality JPG.
Please don't put your screenshots into any kind of container file (e.g. DOC, PDF or HTML mail), but send them as single files or in one ZIP archive. To describe the specific steps you can use a plain text file or the body of your mail.